Features
- Non-flammable CO activating material
- Generation of small amounts of CO
- Generation of CO during testing only
- No storing of pressurized CO - no dangerous goods
- More productivity than the spray can
CO capsule for multi-stimulus detector tester 805551
Replacement CO capsule (Testifire TC3) for the testing of detectors with carbon monoxide sensors (CO). Especially suited for the OTG multisensor fire detector (CO) IQ8Quad with isolator (Part No. 802473). Suitable for the multi-stimulus detector tester Part No. 805551.
- Part-No.:
- 805553
Technical Data
- Common technical data:
- Leistungserklärung
- Rated voltage
- V AC
- Rated frequency
- Rated current
- Output current
- Battery capacity
- Operating voltage
- Operating voltage
- V DC
- Operating voltage
- Quiescent current
- Lichtquelle
- Leuchtfarbe
- Quiescent current @ 9 V DC
- μA
- Quiescent current @ 12 V DC
- Quiescent current @ 19 V DC
- μA
- Quiescent current @ 24 V DC
- Quiescent current @ FACP battery
- Quiescent current @ FACP battery
- Quiescent current
- μA
- Current consumption
- Current consumption
- Current consumption @ 12 V DC
- Current consumption @ 24 V DC
- Starting current
- mA
- Current consumption in the case of failure
- mA
- Current consumption testmode
- mA
- Alarm current
- Alarm current
- Alarm current @ 9 V DC
- mA
- Alarm current @ 12 V DC
- Alarm current @ 24 V DC
- mA
- Alarm current @ 24 V DC
- Alarm current w/o communication curtain
- mA
- Power consumption
- Current consumption for ext. devices
- A
- Testing capacity
- Battery charging
- Heat detector response threshold
- Load factor
- Contact load relay
- Contact load
- Sound level
- dB
- Sound level @ 12 V DC
- Sound level @ 24 V DC
- Sound level
- No. of detector/zone
- Circuit
- Display
- Operation indicator
- Alarm display
- Fault display
- Frequency of flash
- Lighting energy
- Flash color
- Luminous intensity
- Signal flashing lamp
- Range
- Connection terminal
- CO pre-alarm
- ppm
- CO alarm
- ppm
- Area to be monitored
- Height to be monitored
- Air velocity
- Sensitivity
- Application temperature
- Ambient temperature
- Storage temperature
- Air humidity
- Air humidity
- Type of protection
- Protection class
- Ex. protection
- Category
- Housing
- Material
- Installation
- Signal Range
- Mounting height wall
- Room width
- Category ceiling
- Mounting height ceiling
- Room diameter
- Color
- Weight
- Weight
- Optisches_Signalbild
- Lebensdauer_optisch
- Drehfrequenz
- Abmessungen
- Content
- Cable length
- m
- Maximum sensor length
- m
- Detector specification
- DIBt approval
- Specification
- Cable diameter
- mm
- Cable entry
- Maximum tube length
- Dimensions
- Length
- Declaration of Performance
- Konformität
Additional information
The OTG multisensor fire detector (CO) IQ8Quad with isolator (Part No. 802473) is generally tested either
-with the test gas Part No. 805584/805584.50, suitable for the smoke detector tester Part No. 805582, or
-with Part No. 805552, suitable for the multi-stimulus detector tester Part No. 805551.
The Part No. 802473 is VdS-approved as a smoke detector, the CO test gas is required for the additional triggering of the electrochemical CO gas cell.
Downloads
